ABSTRACT
The need for a remote control system that can control domestic appliances and various lighting points and sockets has often been a concern for uses at times uses find it inconvenient and time they are leaving the house for work it has also often led to damage of appliances due to the fact that an appliances was not timed off before leaving the house.
The objective of putting up. This project therefore is to design equipment that can facilitate a convenient and easy way of controlling our domestic appliances lighting points and sockets especially in powering by ourselves. This objective will be accomplished using various components which include a microcontroller project together with other component.
TABLE OF CONTENT
Title Page
Certification
Dedication
Acknowledgement
Abstract
CHAPTER ONE: INTRODUCTION
1.1 Objective of Project
1.2 Justification of Project
1.3 Scope of Diagrams in Project
1.4 Block diagram of project
1.5 Project report organization
CHAPTER TWO
Literature review
2.1 Review of remote control systems
2.2 Description of project
2.3 Use of project
CHAPTER THREE
3.0 Research methodology
3.1 Information gathering
3.2 Hardware components analysis
3.3 System design approach
3.4 Choice of design
3.5 The process flow chart
CHAPTER FOUR
Design
4.1 The hardware subsystems
4.2 Microcontroller (AT89C51)
4.3 The input interface design
4.4 The output interface design
4.5 Control software program design
CHAPTER FIVE
System testing, implementation and evaluation
5.1 System testing
5.2 Choice of programme language
5.3 Expected test results
5.4 Performance evaluation
CHAPTER SIX
Summary and Conclusion
6.1 Summary
6.2 Problems encountered
6.3 Recommendation for further improvement
6.4 Conclusion
References
Appendix A: System components
Appendix B: Component cost analysis
Appendix C: Diagram of the microcontroller
CHAPTER ONE
INTRODUCTION
1.1 OBJECTIVE OF PROJECT
The need for a remote control alert system that can control domestic appliances and various lighting points and sockets has often been a concern for users. At times users find it inconvenient and time consuming to go around turning their appliances on or off each time there is power outage or each time they are leaving the house for work. It has also often led to damage of appliances due to the fact that an appliance was not turned off before leaving the house.
The Objective of putting up this project, therefore, is to design an equipment that can facilitate a convenient and easy way of controlling our domestic appliances, lighting points and sockets especially in powering them, without always going to appliances physically by ourselves.
This objective will be accomplished using various components which include a Microcontroller (AT89C51) which....================================================================
Item Type: Project Material | Size: 82 pages | Chapters: 1-5
Format: MS Word | Delivery: Within 30Mins.
================================================================
